Basic Guidelines For Keeping Your Trees Healthy

1.Watering

All trees ― even the drought-tolerant kinds ― need regular water during the first several years after planting, until the roots have grown deep enough to carry the plant through dry periods. Once established, however, most trees require only infrequent irrigation.

Water deeply rather than frequently. Because most tree roots are found in the upper 18 - 24 inches of the soil, this is the zone that should be wetted up in each irrigation cycle. Each deep irrigation will meet a tree's water needs for between 10 days to 4 weeks during the hottest part of the summer, depending on the tree species and soil type.

Stop watering when runoff starts. Soils high in clay accept water slowly, often as little as 1/4 inch per hour. Water infiltration is especially slow in compacted soils. If water starts to pool or run off, stop irrigating, let the water soak in, and start watering again. Repeat on/off cycles until you apply enough water to wet the soil to 18-24 inches. This may take a number of cycles over several consecutive days.

Don't saturate the soil for long periods. Water displaces air in the soil, so long periods of soil saturation can suffocate growing roots. Take a long enough break between irrigation cycles to allow the free water to be absorbed. If in doubt, probe or dig to make sure that the soil isn't soggy below the surface.

2.Fertilizing

Regular fertilizing, too, is needed for a few years after planting. By ensuring a nitrogen supply for the springtime growth surge, you'll encourage young trees to get established quickly. Once a tree is well settled in, though, it may grow satisfactorily with no further feeding ― and in fact, fertilizing a tree that continues to put out healthy, vigorous new growth is a waste of both time and fertilizer. But feeding may be in order if a tree's new growth is weak, sparse, or unusually pale, or if the tree has a fair amount of dieback that can't be ascribed to over- or underwatering.

3.Forming a strong tree trunk

Young trees develop a strong trunk more quickly if their lower branches are left in place for the first few years after planting; these branches also help shade the trunk. During this time, shorten the side branches only if they become too long or vigorous, pruning during the dormant season or just before spring growth begins. Once the trunk is at least 2 inches thick, begin removing the lower branches gradually, over a period of several years.

4.Staking young trees

A young tree will develop a sturdier trunk if it grows unsupported and can sway in the breeze. Stake it only if it is planted in an extremely windy location or if the main trunk is too weak to stay upright on its own. Use ties that won’t bind or cut into the bark, such as wide strips of canvas or rubber; fasten each tie around the tree and both stakes in a figure-8 pattern, as shown above. The tree should be able to move an inch in either direction.

To figure out where to attach the ties to a weak trunk, run your hand up the trunk until you find the point where the top no longer flops over. Cut off the stakes an inch or so above the ties. In a windswept site, a young tree’s roots may need anchoring to keep them in firm contact with the soil; use stakes and ties only a foot above ground level for this kind of staking. In both cases, sink stakes at right angles to the prevailing wind. Remove them after about a year or as soon as the tree appears to be self-supporting.

How you water your new plants can make all the difference. Deeper, less frequent watering will grow plants whose roots are deeper and healthier, so they are more resilient to drier conditions and stress. Water a plant immediately when you plant it. If watered properly the first growing season, your plants should be well established the following growing season. Their roots should be deep and tough enough to seek out water on their own. You will only have to water these established plants on hot, dry days or if they are showing signs of distress.

The following are general guidelines. How often and how long you water will depend on your soil and other factors.

1.Year One

When planting water plants as soon as you get them in the ground. Allow the water to soak in and drain, and water again, until the soil is thoroughly moistened.

2.For the first week or so after planting

Water just-planted plants frequently - daily or every other day - as the roots will not be able to access soil moisture from a very large area until they begin to grow.

3.After the first week or so

Unless the weather is extremely hot and dry, you may be able to decrease watering frequency, perhaps to two or three times per week, for the next month or so.

4.Years Two to Three

You should need to water deeply only once or twice per week in dry weather if you have selected the right plant for the right place, prepared the soil and planted correctly, and mulched your plants. Exactly how often and how long you water will depend on your soil and other conditions.

5.After Year Three

Properly planted and watered, plants should be fairly well established by now, and can thrive with less watering than you may expect.

Helpful Tips

• Know your soil type, as this greatly affects watering frequency and duration.

• Allow the top inch or two of soil to dry between waterings to encourage deep roots.

• Group plants with similar water needs together.

• Consider using soaker hoses, as you can get water where you need it and lose less to evaporation.

• Young trees will need deep regular watering during their growing periods. During periods of little or no rain, water deeply once a week until they become established. Water established trees during heat waves and drought conditions.

• Spot-water plants with different needs than the rest of the planting bed.

• Remember that shallow-rooted plants such as rhododendrons, azaleas, heathers and bedding plants may continue to need more frequent watering than most other plants.

• Mulch for moisture. Mulch reduces water loss and adds humus to your soil to retain more moisture.

• Check for soil moisture before – 

Before you water:

Generally, you want the soil to be dry an inch or two below the surface before you water, so probe with a spade or trowel to check.

At least one hour after you water (or longer with clay soil):

Probe into the soil again to see how deeply the water penetrated. Did it penetrate all the way to the root zone? If not, you may need to increase your watering time. But if the area looks well-saturated, you may want to cut back the next time.

Conversely, deep, infrequent watering during hot, dry weather is important to maintain a healthy lawn. Deep watering encourages the turf to develop a deeper, more extensive root system. The denser root system will make your grass less susceptible to periods of drought. A more dynamic root system will also offer the fringe benefit of discouraging competition from weeds.

To determine how long you have to run your sprinkler or irrigation system, take a flat-bottomed container such as a coffee can and mark off half-inch increments. Place the can or cans where it will be hit by the water, and time how long it takes to gather a half-inch of water. Then run your sprinkler twice as long. You may need to apply water even slower to steep slopes to avoid wasting water to runoff.

Netro's motto when it comes to watering: slowly, deeply, infrequently. Netro's algorithm is based on expert gardening knowledge, one of which is to avoid watering equally everyday and instead to water less frequently but deeply. Netro waters your garden only when the soil is dry enough in order to draw more oxygen into the roots, leading to a lusher landscape. By default, we allow the moisture level to deplete to 50% (recommended by EPA) before next watering and that is why you might see longer watering duration than the original settings on your old controller.

Netro smart controller gives your lawn the right amount of water, assures that your garden is getting its required amount of water – no more, and no less.